Home首页Laman UtamaPackages配套Pakej

Package levels配套级别Tahap pakej

Essential · Signature · Bespoke

Pick a standard to build from. Essential is our minimum recommended specification — not the cheapest possible build.

Essential, Signature and Bespoke — the same kitchen shown at three specification levels, priced per quotation
Illustrative design render — the same layout shown at three specification levels.

The three, at a glance — before the full tables

Essential

The minimum recommended specification — not the cheapest possible build.

Best for适合Sesuai untuk
Rentals, tight budgets, large repeatable runs.
Main advantage
Lowest cost per metre, still properly specified for its zone.
Main compromise
Standard hardware and finishes; fewer organisation options.

Bespoke

Full-house, made-to-spec.

Best for适合Sesuai untuk
Whole-home projects and specific requirements.
Main advantage
Custom organisation and premium hardware throughout.
Main compromise
Highest cost, priced per quotation; longer planning.

Full includes / excludes for every product are in the tables below.

Essential

Minimum recommended ALUMAX standardALUMAX 推荐的最低标准Standard minimum ALUMAX yang disyorkan

Practical and cost-controlled — without dropping below ALUMAX’s basic material and installation standard. Not the cheapest possible specification.实用且成本可控——但不低于 ALUMAX 的基本材料与安装标准。并非可能的最低价规格。Praktikal dan terkawal kos — tanpa jatuh di bawah standard bahan dan pemasangan asas ALUMAX. Bukan spesifikasi paling murah yang mungkin.

Complete kitchen — RM11,399–13,300 (8–16 ft)整厨 — RM11,399–13,300(8–16 ft)Dapur lengkap — RM11,399–13,300 (8–16 kaki)

Includes包含Termasuk

  • Plywood for dry and semi-dry cabinet boxes at the published Essential rate, with E1 / E0 / ENF low-emission grades where specified — P6 particleboard stays available as a lower-cost specification for a dry run干区与半干区柜身采用夹板,即公布的 Essential 价位标准,并在指定处提供 E1 / E0 / ENF 低甲醛释放等级——干区仍可选用价格更低的 P6 刨花板规格Papan lapis untuk kotak kabinet zon kering dan separa kering pada kadar Essential yang diterbitkan, dengan gred pelepasan rendah E1 / E0 / ENF di mana dinyatakan — papan partikel P6 kekal tersedia sebagai spesifikasi kos lebih rendah untuk larian kering
  • Standard soft-close hardware标准缓冲五金Perkakasan tutup lembut standard
  • Standard melamine / laminate finish标准三聚氰胺 / 防火板饰面Kemasan melamin / laminat standard
  • Basic internal compartments基础内部分隔Petak dalaman asas
  • Basic installation基础安装Pemasangan asas
  • Basic warranty confirmed per quotation按报价确认的基础保修Waranti asas disahkan mengikut sebut harga

Excludes不包含Tidak termasuk

  • Countertop (unless stated) & premium hardware台面(除非另有说明)与高端五金Permukaan meja (kecuali dinyatakan) & perkakas premium
  • Pull-out pantry / magic corner / premium drawers拉篮储物 / 转角拉篮 / 高端抽屉Pantri tarik-keluar / magic corner / laci premium
  • LED lighting & glass doorsLED 灯光与玻璃门Lampu LED & pintu kaca
  • Aluminium-frame doors & wet-zone aluminium upgrade铝合金框门与湿区铝合金升级Pintu bingkai aluminium & naik taraf aluminium zon basah
  • Special finishes & complex site correction特殊饰面与复杂的现场修整Kemasan khas & pembetulan tapak kompleks
  • Appliance supply; plumbing/electrical/tiling unless stated电器供应;水电/瓷砖(除非另有说明)Bekalan perkakas; paip/elektrik/pemasangan jubin melainkan dinyatakan
Estimate My Project估算我的项目Anggar Projek Saya

Bespoke

Custom — larger, wet & full-house kitchens定制——更大、湿区及全屋厨房Tempahan khas — dapur lebih besar, basah & seluruh rumah

Reserved for full-house cabinet packages, wet kitchen systems, office fit-outs, aluminium-heavy projects, large wardrobes, multi-space projects and special site conditions.专用于全屋橱柜配套、湿厨房系统、办公装修、铝合金为主的项目、大型衣柜、多空间项目以及特殊现场条件。Dikhaskan untuk pakej kabinet seisi rumah, sistem dapur basah, kelengkapan pejabat, projek berat-aluminium, almari pakaian besar, projek pelbagai ruang dan keadaan tapak yang khas.

Complete kitchen from RM22,000 (18–20 ft + island; larger scope to project)整厨 从 RM22,000 起(18–20 ft +中岛;更大范围按项目计)Dapur lengkap dari RM22,000 (18–20 kaki + pulau; skop lebih besar mengikut projek)

Reserved for适用于Dikhaskan untuk

  • Wet kitchen systems & full-house packages湿厨房系统与全屋配套Sistem dapur basah & pakej seluruh rumah
  • Commercial office fit-outs (PROWORKS)商用办公装修(PROWORKS)Naik taraf pejabat komersial (PROWORKS)
  • Aluminium-heavy & large-wardrobe projects铝合金为主与大型衣柜项目Projek berat aluminium & almari besar
  • Special site conditions & custom dimensions特殊现场条件与定制尺寸Keadaan tapak khas & dimensi tempahan khas
  • Multiple product categories多个产品类别Berbilang kategori produk
  • Design & quality-check support from ELS by ALUMAX where applicable在适用情况下,由 ELS by ALUMAX 提供设计与质量检查支持Sokongan reka bentuk & semakan kualiti daripada ELS by ALUMAX di mana berkenaan
Estimate My Project估算我的项目Anggar Projek Saya
On pricing.关于价格。Mengenai harga. Indicative ranges only — prices are exclusive of SST and subject to measurement, material, dimensions, hardware, countertop, site condition, service level and approved drawing. Aluminium doors and windows are quoted separately by opening size and specification. Final quotation depends on actual measurement and an approved drawing.仅为参考范围——价格不含 SST,并视现场测量、材料、尺寸、五金、台面、现场状况、服务级别及已批准图纸而定。铝合金门窗按洞口尺寸和规格单独报价。最终报价取决于实际测量和已批准图纸。Julat sebagai panduan sahaja — harga tidak termasuk SST dan tertakluk pada ukuran, bahan, dimensi, kelengkapan, permukaan atas, keadaan tapak, tahap perkhidmatan dan lukisan yang diluluskan. Pintu dan tingkap aluminium disebut harga secara berasingan mengikut saiz bukaan dan spesifikasi. Sebut harga akhir bergantung pada ukuran sebenar dan lukisan yang diluluskan.

What ALUMAX does / does not automatically includeALUMAX 默认包含 / 不包含的项目Apa yang ALUMAX sertakan / tidak sertakan secara automatik

Included by default默认包含Disertakan secara lalai

  • Cabinet / aluminium / office system supply橱柜 / 铝合金 / 办公系统供应Bekalan kabinet / aluminium / sistem pejabat
  • Material and hardware selection材料与五金选配Pemilihan bahan dan perkakasan
  • Product quotation产品报价Sebut harga produk
  • Installation under confirmed scope在确认范围内的安装Pemasangan di bawah skop yang disahkan
  • Warranty and handover documentation保修与交付文件Dokumentasi waranti dan penyerahan

Excluded unless stated除非注明,否则不含Dikecualikan kecuali dinyatakan

  • Countertop台面Meja dapur
  • Electrical works电气工程Kerja elektrik
  • Plumbing relocation水管改位Pemindahan paip air
  • Tile hacking瓷砖拆除Pemecahan jubin
  • Waterproofing防水工程Kerja kalis air
  • Ceiling works天花工程Kerja siling
  • Painting油漆工程Kerja mengecat
  • Appliance supply电器供应Bekalan perkakas
  • Full renovation management整体装修管理Pengurusan pengubahsuaian penuh

These can be added — they’re just quoted as separate, clearly-stated items so your budget stays clear. Final scope follows site measurement and an approved drawing.这些都可以增加——只是会作为单独、清晰列明的项目报价,让您的预算保持清晰。最终范围以现场测量与已批准图纸为准。Ini boleh ditambah — ia hanya disebut harga sebagai item berasingan yang dinyatakan dengan jelas supaya bajet anda kekal jelas. Skop akhir mengikut ukuran tapak dan lukisan yang diluluskan.

Package level vs. service level配套级别与服务级别Tahap pakej berbanding tahap perkhidmatan

The package配套pakej is the product specification (material, hardware, finish). The是产品规格(材料、五金、饰面)。而ialah spesifikasi produk (bahan, perkakasan, kemasan). service level服务级别tahap perkhidmatan is how much ALUMAX coordinates around it.则是 ALUMAX 在此之外参与协调的程度。ialah sejauh mana ALUMAX menyelaraskan di sekelilingnya.

ALUMAX Product-OnlyALUMAX 仅供产品ALUMAX Produk Sahaja

For clients who already know what they need适合已明确需求的客户Untuk pelanggan yang sudah tahu apa yang mereka perlukan

Straight supply and installation of a defined product.对已确定产品的直接供应与安装。Bekal dan pasang terus bagi produk yang telah ditetapkan.

  • Product recommendation & material selection产品推荐与材料选择Saranan produk & pemilihan bahan
  • Basic quotation基础报价Sebut harga asas
  • Supply & production供应与生产Bekal & pengeluaran
  • Standard installation where applicable适用情况下的标准安装Pemasangan standard di mana berkenaan
  • Product warranty as stated按说明提供的产品保修Waranti produk seperti dinyatakan

ALUMAX + ELS

For clients who need help deciding适合需要协助决策的客户Untuk pelanggan yang perlukan bantuan membuat keputusan

Guidance on layout, material, style, appliance and budget decisions — not full interior design.在布局、材料、风格、电器与预算决策方面提供指导——并非完整的室内设计。Panduan tentang keputusan susun atur, bahan, gaya, perkakas dan bajet — bukan reka bentuk dalaman penuh.

  • Budget Range Pre-Check预算范围预检Pra-Semakan Julat Bajet
  • Product configuration & material recommendation产品配置与材料推荐Konfigurasi produk & cadangan bahan
  • Basic layout direction基础布局方向Hala tuju susun atur asas
  • Colour / finish recommendation颜色 / 饰面推荐Saranan warna / kemasan
  • Quotation based on selected scope基于所选范围的报价Sebut harga berdasarkan skop yang dipilih

ELS CoordinationELS 统筹协调Koordinasi ELS

For larger, multi-space projects适合较大型、多空间的项目Untuk projek yang lebih besar dan berbilang ruang

We coordinate the whole project end to end with ELS by ALUMAX — our in-house design and technical-development side — leading design, specification and quality-check.

  • Site measurement & scope confirmation现场测量与范围确认Ukuran di tapak & pengesahan skop
  • Material & hardware schedule材料与五金清单Jadual bahan & perkakasan
  • Drawing approval & sign-off to build图纸批准与开工签认Kelulusan lukisan & pengesahan untuk mula membina
  • Installation & change-note control安装与变更单管控Kawalan pemasangan & nota perubahan
  • Handover & warranty documentation交付与保修文件Penyerahan & dokumentasi waranti

ALUMAX + ELS consultation may require a pre-check or design fee, creditable upon confirmed project order where applicable. ELS Coordination service is available for selected projects depending on scope, site condition, location and timeline.ALUMAX + ELS 咨询可能需要预先检查或设计费,在确认项目订单后可于适用情况下抵扣。ELS 统筹协调服务面向特定项目,视范围、现场状况、地点和时间安排而定。Perundingan ALUMAX + ELS mungkin memerlukan yuran semakan awal atau reka bentuk, boleh dikreditkan apabila pesanan projek disahkan jika berkenaan. Perkhidmatan Penyelarasan ELS tersedia untuk projek terpilih bergantung pada skop, keadaan tapak, lokasi dan garis masa.

Which fits you?哪一个适合您?Yang mana sesuai untuk anda?

Match your situation to a package and service level.将您的情况匹配到合适的配套与服务级别。Padankan situasi anda dengan pakej dan tahap perkhidmatan.

Larger or multi-trade project?较大或多工种项目?Projek lebih besar atau melibatkan pelbagai kerja pakar? Bespoke work — full-house, wet kitchens, office fit-outs or several trades on one site — is designed, developed and coordinated by ELS by ALUMAX: layout, material specification, approval documents, trade coordination and the QC standard ALUMAX builds to. See when ELS support is needed ↗了解何时需要 ELS 支持 →Lihat bila sokongan ELS diperlukan ↗
Ask on WhatsAppWhatsApp 咨询Tanya di WhatsApp